No Description
esell cdf67f86e1 drone 8 months ago
src blah 8 months ago
.drone.yml drone 8 months ago
.gitignore blah 8 months ago
Makefile.am blah 8 months ago
README.md blah 8 months ago
configure.ac blah 8 months ago

README.md

About

Tracker is a program I created to help with tracking your HAB via radio. It was built around the Raspberry Pi 3, NTX2 transmitter and the Adafruit Ultimate GPS.

Once tracker is started it will read GPS data from the local gpsd daemon and send it out in RTTY for you to read.

Because I’m horrible with C, almost all of this code was lifted from the following sources and put together in a horrible mess:

https://ava.upuaut.net/?p=627

http://www.airspayce.com/mikem/bcm2835/index.html

http://catb.org/gpsd/

Pre-reqs

  • gpsd running on the Pi on the default port

Use

To run on the Pi, start gpsd first:

sudo gpsd /dev/serial0 -F /var/run/gpsd.sock

Then start up tracker:

sudo /usr/local/bin/tracker

sudo is needed to help get tracker into a more “real-time” mode.

Reading the data

I use software to receive the signals so my setup consists of gqrx and fldigi. Whatever you use you will want to set your RTTY config to

  • 50 baud
  • 7 bits
  • no parity
  • 2 stop bits

The carrier shift will depend on how you’ve setup the NTX2, mine works well around the 650 range.

Building

To build from source you will need the autotools suite. You will also need the bcm2835 library as well as the gpsd library (see links above).

Checkout the source and run:

autoreconf --install

./configure

make

sudo make install